Superelevation is a tabular note that goes on the general info sheet with the super elevation diagram, so we usually just fill out the info in that tabular note. Designers just blow up the tabular note to add lines and make it work per project. If...

The "Text View Readable" option for Civil Laballer a nd Annotation Manager/groups respects only the model Active Angle. Refer to my case CS0042880 for more info. It should be a dynamic function that always respect the view, so no matter from which...

In ORD when you attempt to measure the graphics within a XS View it appears that you get the surface area of the entire cut or fill volume. As a user, I need the specific end area for the element. Presently you have to trace the element with a mea...

Civil Labels can get dissassociated for a number of reasons. When this happens, the user often deletes the text that turns dashed. This, however, does not delete the circle associated with the text. Due to this, the remnant circle is left. This ca...

In ORD, In the Template window, would be beneficial to be able to create EC components made up a series of template points and "break" them into separate components and then merge them back together.

Synchronized scrolling would be really helpful when you have parallel tracks and need to review them and check that they have the same geometry. It could also be good to be able to have the ability for synchronize scrolling between plan and profil...

Currently, the "Analyze Volume" tool "Only" allows you to use an ORD Geometry Shape for a boundary. It would be much more useful and intuitive if we could also use a fence and/or a regular MicroStation shape for a boundary as well like you could w...

For Steel bridge modelling, for the beam definitions, the only possible options are defining rolled or built-up shapes or defining Tub Girders. It would be very beneficial to have an option or steel beams to define custom cross sections similar to...

Currently, is possible to create and personalice reports (Analise)using Item Types data, however,there is no relation back. It would be very benifecial if data added or even changed into the reports could be imported back into the model and Item T...

it would be more accurate to calculate the structure Height if when a pipe is connected to a structure that the bottom base slab was adjusted to be below the wall of the pipe. this would also make the 3D model look better.