Need Support? Let’s guide you to the right answer or agent.

OpenTunnel Ideas Portal

ADD A NEW IDEA

OpenRail Designer

Showing 68

Remove length restriction in offset geometry command

Please remove the restriction that makes it impossible to make the offsetted element longer than the base element. It is normally the direction that is important and the length can be edited afterwards. Otherwise add an opportunity to remove the r...
about 2 months ago in Geometry / OpenRail Designer 0 Needs review

Drainage Annotation rotation based on sheet view rotation

Currently, the only rotation options for drainage annotation is constant. With alignments that are curving, our sheets must change rotation. It would save a lot of time spent manually adjusting rotation on each sheet.
6 months ago in Annotation / Drainage and Utilities / OpenRail Designer / OpenRoads Designer 2 Needs review

Ability to manage outer/inner pipe wall symbology separate from linear/profile symbology settings.

Need the ability to see wall symbology but not centerline. If the centerline symbology is set to construction class so are the inside/outside walls and they don't print. If the centerline is set to 255 the inside/outside walls do display in print ...
about 2 months ago in Drainage and Utilities / OpenRail Designer / OpenRoads Designer 0 Needs review

Enhancement::Additional Tool for Design of Cross over connection between Tangent & Canted Tracks

I suggest improvements to Bentley OpenRail Designer for handling Cross over connections in the following scenarios: Cross over Between Adjacent Tangent Tracks: Enable a simple geometric connection between two parallel tracks without the use of Geo...
9 months ago in OpenRail Designer / Turnouts/Crossings 0 Needs review

New turnouts, verify branch geometry

New turnouts, verify branch geometry like in (BRTRACK button there was a button
about 1 month ago in Geometry / OpenRail Designer 0 Needs review

Unable to report on Geometric Points direction relative to an Alignment.

In OpenRail Designer, unable to output the direction information when comparing geometry points to a baseline alignment. In Bentley Rail Track we were able to create clearance reports that included the direction. It appears OpenRailDesigner's repo...
over 1 year ago in OpenRail Designer 2 Needs review

Point Code and number included in the regression points

The point code and number should be included in the regression points so that it can be printed out and identified when you make a regression report. If you only see the stationing and offset from the geometry you cannot separate normal track poin...
8 months ago in OpenRail Designer / Regression Analysis 0 Needs review

Verify Turnout

Use the Geometry Connector with start and end elements chosen as turnouts. The converged result gives a disconnection between the regression alignment and the turnout. You can only discover it by zooming in to the closest possible view. A "Verify ...
4 months ago in OpenRail Designer / Turnouts/Crossings 0 Needs review

Improve the Cant report such that the exact stations where speed changes is reported correctly

Currently we can generate the cant report with an specified interval. The issue with these report is that the exact station at which the speed changes can be interpreted incorrectly. for example. Consider an alignment in the with 100mph speed, dro...
about 2 months ago in CANT / OpenRail Designer / Reports 0 Needs review

Multiple linked speed schemes to each cant table

I would like to have the possibility to link multiple speed schemes/train categories to each cant table in a way that makes it possible to create a report that includes cant, cant deficiency, sudden changes etc, for all speed schemes in one place ...
8 months ago in CANT / OpenRail Designer 0 Needs review