Need Support? Let’s guide you to the right answer or agent.

OpenTunnel Ideas Portal

ADD A NEW IDEA

Ideas

    Showing 1752 of 1752

    Horizontal and vertical regression values displayed in mm

    Reporting horizontal slues and vertical lift/lowers interactively in the plan or profile model always displays as per the working unit, which I have set to metres. It would be useful to display these values in millimetres
    about 3 years ago in Regression Analysis 0 Planned

    Option to refresh/update/revise geometry point sequencing

    When designing different types of sites/pads etc, it is very typical to provide set out points on our drawings. The issue is that designs can change requiring us to remove certain points which will leave a gap in the point sequencing. There needs ...
    4 months ago in Geometry / OpenRoads Designer 0 Future consideration

    Export alignment in read-only file as LandXML

    I have opened an ORD .dgn design in read-only mode. This is not uncommon, especially when using ProjectWise and the file is either at coordination/shared state, or checked out to another user. However, it is not possible to export the alignment us...
    about 2 years ago in Import/Export / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

    Tangent Profile Line from Element tangent point handle in ORD 10.10 - 23.xx

    Request to bring back the tangent point handle when using the Tanget Profile Line from Element tool as described in the forum link below. SS10 had this ability and no longer found in ORD 10.10 through 23.00.xx https://bentleysystems.service-now.co...
    over 1 year ago in Geometry / User Interface 0 Future consideration

    GEOPAK-like Drainage Tools

    I would like to see tools added to ORD that would mimic the Drainage Tools found in GEOPAK. Specifically, I would like to be able to visualize Drainage Patterns. I envision this be something that could be added to a Terrain Feature Definition, sim...
    about 3 years ago in Drainage and Utilities / OpenRail Designer / OpenRoads Designer / OpenSite Designer / Terrain 2 Future consideration

    Update Previously Placed Civil Labels When Reference Properties are Updated

    For example, when using a Civil Label to label a drainage node with a Text Favorite pointing to the Feature Name, the placed label does not update when the Feature Name is changed.
    4 months ago in Annotation 0

    Command to locate the midpoint between 2 points ala MTP or M2P in C3D

    A command where, once activated, would prompt the user to select the first point, then the second point, and then the user's cursor would snap to a location located exactly in between the two points. This could be done without drawing any unnecess...
    4 months ago in OpenRoads Designer 0 Future consideration

    Split Drainage Node Baseline Reference into Station Reference and Offset Reference

    Drainage nodes currently utilize an Elevation Reference and a Baseline Reference. It would be better to split the Baseline Reference into two separate references, 1) "Station Reference", and 2) "Offset Reference". In practice, this would allow a n...
    4 months ago in Drainage and Utilities / OpenRail Designer / OpenRoads Designer / User Interface 0 Already exists

    Location of embedded battered piles set at bottom of footing

    Currently, for abutment and piers, when battered piles are used in combination with an embedment length, the pile location is set based on top of pile not the bottom of footing. When users input pile spacings into the pile layout dialog, it is not...
    7 months ago in Modeling / OpenBridge Modeler 0 Planned

    Ability to assign varying ledge heights on either side of an inverted tee cap.

    useful feature when we have varying girder depth on either side of an inverted tee cap. currently ledge depth has to be same on either side , and the pgl is achieved by using thickened bearing seats
    7 months ago in Geometry / OpenBridge Modeler 1 Already exists