ORD to allow vertical profile offset tool to snap to CAD lines. When alignments change horizontally, profile offsets do not retain snaps to features including CAD lines.
Create 3D by slope to target tool alse creates 2D geometry
This tool should work similar to a linear template. It should respect the "Create Template Geometry" option from the feature definition and generate the 2D geometry, not just the 3D one.
Want the ability to annotate every special point of the horizontal & vertical alignment with a number in sequence. You can veiw a sample of the profile annotation needed in the image below or in the PDF attached. This type of annotation is com...
about 2 years ago
in Annotation
0
Future consideration
Manual Editing of Cant: Make it easier and allow it to be permanent.
The "ruled" cant tries its best to calculate appropriate values of superelevation. Usually, these end up being over-ridden for many reasons, good or bad. Turning off the rules in Cant editor allows manual editing, but it is very time consuming, "r...
Please add a variable MS_LEVEL_DO_NOT_OVERRIDE_DESIGN_LEVELS_IN_DRAWING that does what MS_LEVEL_DO_NOT_OVERRIDE_DESIGN_LEVELS_IN_SHEET does for sheets but for drawings
IDS as Information Delivery Specification is a standard comes from buildingSMART which ensure openBIM pricipes for exchange of information requirements and validation. Please check at https://www.buildingsmart.org/what-is-information-delivery-spec...
0
Future consideration