Current default setting shows Vertical Curve Parameter or K-Value below the parabola length in the dynamic display of a vertical alignment. The geometry report has to be run or the annotation must be displayed to see the available SSD. It would be...

We need ability to label height difference between centerline and curb or other key-point in our type XS. Or ability to label curb or other key-point height relative to centerline.

Say if I had pre-cast units (say rectangular for ease of the idea), you can see the coordinates of the 4 bottom corners (or other named points) of the pre-cast unit if I click on it. This would show up in model space view as shown: https://imgur.c...

A functionality in the Regression Points Table, particularly for deleting the points are missing in this table. The current workaround is to navigate through Explorer and delete the regression points, one by one, which is an issue if you have many...

I'm surprised ORD doesn't automatically include an interval at the point in which cut slope becomes fill slope or vice verse. MX did a great job at this but without this function earthwork slopes aren't correct and give strange results. It's not p...

I would like to see some of the tools from OpenCities, mainly the ability to read a geodata base, integrated into OpenRoads. Since Bentley Map was removed from the Select Series application and not added to the OpenRoads, we have very little GIS i...

I noticed that template ranges can overlap and there is no obvious indication that this is occurring. Ideally over lapping station ranges should highlight in red to draw attention to it.

With the ability to add so many references, it would be helpful to have the ability to organize them better. It would be useful to group similar references together in a folder within the reference window. Example being; all utility references in ...

now we can only annotate the cut and fill in X-section, we need to be able to annotate also the different components

This improvement would use graphic symbols (construction elements) to represent constraint relationships in plan view. For horizontal elements that are snapped, there are the snap glyphs that show that there is a relationship, but there is not a w...