Need Support? Let’s guide you to the right answer or agent.

OpenTunnel Ideas Portal

ADD A NEW IDEA

All ideas

Showing 1650

LIFT vrs slew report

Hi would be very helpful to get a lift vrs Slew report at set chainages along an alignment. This would help the designer see if they are designing enough lift in the track to achieve the slews, without going to the drawing production stage
over 2 years ago in OpenRail Designer / Regression Analysis 0 Future consideration

Enhance Design Standards to flag gaps in Geometry & apply to Feature Definitions

Additional functionality is needed for Design Standards to be fully functional for project delivery. Some additional thins include: Allow Design Standards to be optionally assigned to Alignment Feature Definitions so Alignments are created with th...
over 2 years ago in Geometry / OpenRail Designer / OpenRoads Designer 0 Future consideration

Geometry Connector: Add column for degree of curve for an arc

Please Add column for degree of curve for an arc. The Geometry Connector should show the Degre e of Curve for an Arc, and not just Radius. It is annoying to have to use Excel or a calculator to go back and forth when you need a curve to be a certa...
almost 3 years ago in Geometry / OpenRail Designer 0 Future consideration

Option to keep siding alignment start station in synch with mainline alignment

Option to keep siding alignment start station in synch with mainline alignment as shown in the attached video
almost 3 years ago in Geometry / OpenRail Designer 0 Future consideration

Ability to separate the annotation of curves and spirals for the rail cant

Ability to separate the annotation of curves and spirals for the rail cant. At present the Non-Linear setting is applying to both This is usefull to remove some clutter (especially where there is short elements like below;
almost 3 years ago in Annotation / CANT / OpenRail Designer 0 Future consideration

Add ability to draw Ahead/Back Tangent line for full length from PC to PI and from PT to PI

Currently in annotation group, the back/ahead tangent line drawn at the PI only has the option for a fixed length. We would like the ability to draw back and ahead tangents the full length from PC to PI to PC. This could apply to both horizontal a...
almost 3 years ago in Annotation / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

Ability to automatically generate 3d linear features/Linestrings from OBM elements

Generation of 2d decorations and solids are insufficient for full coordination with road geometry teams and they regularly need to provide 3d linestring geometry as part of the roadway design for bridge barriers, wingwall edges for earthworks, etc...
over 2 years ago in Modeling / OpenBridge Designer / OpenBridge Modeler 0 Future consideration

PMM non-linear springs

We would like to ask a PMM non-linear spring for modeling Plastic Hinges for reinforced-concrete Columns. This PMM springs are used for modeling the Moment-Rotation (M-R) behavior for different axial loads (P). The PMM spring should be able to cap...
10 months ago in Analytics / OpenBridge Designer 0 Needs review

Non automatic update of cant values in cant table

This comment is coupled with another idea I had regarding selective update of annotations. Again the problem stems directly from the dynamic nature of ORD. Usually the process to create a cant for an alignment goes as follows: -Creation of speed t...
about 2 years ago in CANT / OpenRail Designer 0 Future consideration

Add profile annotation location option for annotating conduit description only once

If a conduit is perfectly straight, then it is easy to put the description once in the middle, but if the conduit has any bends then each segment gets annotated. Adding an option for annotation frequency with location controls would fix this.
over 2 years ago in Annotation / Drainage and Utilities / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration