In order for the place bearing tool to work for as many instances as possible, we either need to be able to adjust the bearing's vertical location due to shim plate placement on an individual basis or else allow for different cells to be used at t...
Create a tool to clip an alignment at any location along the alignment that does not affect or change the stationing or the station equations even if you are clipping the beginning of the alignment.
NYSDOT requires that all plan sets include an LFD Load Rating. Until this ability is added to LEAP Steel, we cannot adopt OpenBridge fully and must continue doing our steel design in different software.
For steel beams- When we create stiffeners and use them in cross frame definition, regardless of the method used, the stiffener tables when opened default to the first stiffener in the OBM library rather than the stiffener used in cross frame definition
Currently when we create a new stiffener and then when we create cross frames using those stiffeners, they don't show up when you open stiffener definition after creating cross frames (the first stiffener definition within the selection is shown)
It would be very helpful if there was a way to simply Add a Conduit to an existing Profile Run. For example, I have a storm network modeled and a bunch of drawings created by using a Profile Run, but now I needed to add another conduit at the end ...
Export pier or abutment templates to Functional Component
Often times a small edit is needed to make an existing abutment or pier template match project standards. It is tedious to create a Functional Component from scratch for small edits. It would be helpful to have a tool or button to export a templat...
It would be very usefull to have the ability to place wingwalls with option to follow horizontal alignment including curved alignment. Currently we only have the option to follow the vertical profile.
It would be very useful to have the possibility to create a negative back batter (narrow bottom) for an abutment, since currently the back batter can only be positive (wider bottom).
Civil Cell dgnlib - Sort by name rather than date created
Currently Civil Cells are sorted by date created rather than by name when loaded from a dgnlib. This makes it very difficult to sort these. Oddly, when they are within a file (where the civil cell is "living") they sort by name.
It would be useful to be able to turn on-/off single alignments. Perhaps with a checkbox in the "OpenRail Model" section in the explorer, just like the ones in the "Feature definition" section in OpenRail Standards. This could probably be handy wi...