Need Support? Let’s guide you to the right answer or agent.

OpenTunnel Ideas Portal

ADD A NEW IDEA

All ideas

Showing 1699

MVD is not defined when exported to IFC

In IFC Export, there is NO Model View Definition in exported IFC.
over 1 year ago in Import/Export / OpenBridge Designer / OpenBridge Modeler / OpenRail Designer / OpenRoads Designer / OpenSite Designer / OpenTunnel Designer 0 Future consideration

Add Generate Transverse Feature from InRoads to OpenRoads

This tool was incredibly useful in creating Finished Grade and subgrade terrains, allowing for quick creation of transverse features to control triangulation and slope transitions in intersections and grading. The fact that the lines could be made...
over 2 years ago in Terrain 9 Future consideration

Ability to use end condition exceptions on linear templates

Being able to use end condition exceptions for linear templates would be extremely beneficial for roadway designers. We often use end condition exceptions to turn off slopes in order to connect external features like ditches to the corridor. Not b...
over 2 years ago in Modeling / OpenRail Designer / OpenRoads Designer / OpenSite Designer 2 Future consideration

Ability to group references into folders within ORD

With the ability to add so many references, it would be helpful to have the ability to organize them better. It would be useful to group similar references together in a folder within the reference window. Example being; all utility references in ...
almost 3 years ago in Workspace 0 Future consideration

Ability to Export Profile Run To Consider Node Length

Currently it is not possible to export the alignment and profile from Profile Run with same station as it considers the nodes in the profile. We can select the conduit and export it, but this would be actual conduit length not the center to center...
5 months ago in Drainage and Utilities / Import/Export / OpenRail Designer / OpenRoads Designer 1 Needs review

Ablity to connect two nodes directly by flange

For the water supply project, in a situation where we have cast iron elements connected to the flange such as gate valves, hydrants, elbows, venturiers and plastic line pipes. There is no way to connect the two nodes directly through the flange. a...
over 2 years ago in Drainage and Utilities / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

Add point of reverse curvature on reverse parabolic transition

In the Superelevation Editor, being able to add a point of reverse curvature on reverse parabolic transitions will help when trying to manually define/adjust points of 0% cross slope.
over 1 year ago in OpenRoads Designer / Superelevation 0 Future consideration

Add superelevation point type of "crown removed"

In the Superelevation Editor, adding a "crown removed" option to the Point Type list would help when trying to manually define/adjust anywhere there is 0% cross slope.
over 1 year ago in OpenRoads Designer / Superelevation 0 Future consideration

Create a tool to clip alignments.

Create a tool to clip an alignment at any location along the alignment that does not affect or change the stationing or the station equations even if you are clipping the beginning of the alignment.
about 2 years ago in Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

LFD Load Rating in LEAP Steel

NYSDOT requires that all plan sets include an LFD Load Rating. Until this ability is added to LEAP Steel, we cannot adopt OpenBridge fully and must continue doing our steel design in different software.
about 2 years ago in OpenBridge Designer 2 Future consideration