a Migration Tool for 10-10 to 10-11 workspaces.(or any time a new workspace category is created ie. 10-10, 10-11, 10-12...) Something that can find and copy the modifications made to the 10-10 workspace to suit our particular standards (cells, dgn...

For large scale projects, earthwork volumetric meshes cause considerable deficits in navigation performance due to the high count of vertices and faces to be calculated with each navigational operation. Use of scalable meshes for these components ...

When designing drilled shafts, there is no option to display controlling shear and moment loads (bottom of column). This is needed for the geotechnical engineer on designing th drilled shaft. For column design, it is sometime useful to also show c...

It could be useful for different purposes to be able to create component meshes of defined length (construction, pre cast slab). I suggest to add at least 3 parameters to any component: length of the component: the question is then, where to measu...

Many times a calculated Time of Concentration is less than the minimum used for Intensity. When this occurs in a system of drainage areas (catchments), it helps a designer AND a reviewer to see what the actual Time of Concentration is at a given p...

We recently used ORD to import 200 plus drainage structures from inroads to ORD. It brought in the nodes, but the rotation was off. We had to manually rotate the node to the correct angle. Also, the 2-D and 3-D rotation did not match until the nod...

I have used a 3d measure macro in Microstation for 20 years now. I love it. It would be nice to have this feature in ORD . Would be simple to add. The way the tool would work: Users snap between any two points. I dialog would pop up displaying the...

In modeling the road or site with geometry corner in 90 degrees or sharp, the small arc of corner is required in order to model the round corner. So that no overlap between 3d linear geometry. Software should provide the option to allow the corner...

The insertion point for circular eccentric manhole feature definitions is at the center of the MH 2D top. When it's rotated, it rotates at that point instead of the center of the 3D base. Please create the ability to use the insertion point to set...

I would like to programmatically create a new EventPoint list for an alignment. Looking through the Bentley.CifNET.GeometryModel.Tools.Helpers methods, I found GetEventPointList(Alignment) that returns a List<Bentley.CifNET.GeometryModel.KeySta...