Unlike BRT, ORD does not allow defining different cross-section outlines for the front, middle, and rear of a vehicle. This capability is critical for accurate clearance assessments, especially for vehicles with varying geometry (e.g., tapered cab...

In OpenRail Designer, unable to output the direction information when comparing geometry points to a baseline alignment. In Bentley Rail Track we were able to create clearance reports that included the direction. It appears OpenRailDesigner's repo...

There appears to be a discrepancy in wind load calculations—specifically, the gust factor of 0.85 remains different from AASHTO standards. However, the FDOT Structures Design Guidelines (SDG) 2025 now allow the use of AASHTO Article 3.8, which may...

Have the Civil preference for drainage and utilities as file setting rather than personal preference. There are times we had to change the settings depends on what we are designing. eg. we want to show connecting conduit if we do drainage, not whe...

The point code and number should be included in the regression points so that it can be printed out and identified when you make a regression report. If you only see the stationing and offset from the geometry you cannot separate normal track poin...

This product idea proposes an enhancement to ConceptStation that would allow the sideslope end conditions on multiple roadway alignments to target each other to prevent overlapping slopes. Currently, this is only possible with the intersection, ro...

Create a tool to export the DU project so it can be imported in another OpenRoads/OpenSite/OpenFlows dgn file. This would make possible to easily share projects or merge smaler ones in a compiled file for a macro analisys. Or, like in many cases, ...

The world famious bridge softwares such as Lusas, Midas Civil, Sofistik, Larsa 4D. All of them have been developed Grasshopper Plugin to increase the bridge modeling capacity. Lusas Grasshopper plugin: https://www.lusas.com/products/external_plugi...

Possibility to add/remove/change length of long sleepers sets in turnouts that are placed in a geometry. When you are working with existing geometry and there are turnouts with too long sleepers sets or if you by mistake place a turnout that has a...

Currently, the workflow to achieve this is in general case (including canted track) where profile = lower rail elevation is : Create lower rail of branch line: horizontal offset create rails on main: create rails command Extend slope defined by ma...