Skip to Main Content
Need Support? Let’s guide you to the right answer or agent.
ADD A NEW IDEA

All ideas

Showing 1625

Transpose Element option to Create a Copy.

When using the Transpose tool, the software makes a copy of the element you are selecting to transpose, and that is the element that is reversed, leaving behind the original underneath. Most of the time I do not want a copy of the transposed eleme...

Volumetric Meshes created as Scalable Meshes

For large scale projects, earthwork volumetric meshes cause considerable deficits in navigation performance due to the high count of vertices and faces to be calculated with each navigational operation. Use of scalable meshes for these components ...
16 days ago in Modeling / OpenRail Designer / OpenRoads Designer 0 Future consideration

Include column and shaft controlling service loads (RCPIER/LEAP)

When designing drilled shafts, there is no option to display controlling shear and moment loads (bottom of column). This is needed for the geotechnical engineer on designing th drilled shaft. For column design, it is sometime useful to also show c...
16 days ago in OpenBridge Designer 0 Needs review

Template (ITL): add parameters for component length, spacing and individual

It could be useful for different purposes to be able to create component meshes of defined length (construction, pre cast slab). I suggest to add at least 3 parameters to any component: length of the component: the question is then, where to measu...
17 days ago in Modeling / OpenRail Designer / OpenRoads Designer 0 Future consideration

Need ability of having different Spiral Types in OpenRoads Designer

Need to have an option of having different spiral curve types in OpenRoads Designer mainly cubic parabola which is similar in OpenRail Designer. This is also required to satisfy new expressway design specification as per table no 2.4 in clause no ...
about 1 year ago in Geometry / OpenRoads Designer 0 Future consideration

Add Elevations to the Event Point List Table

The elevations of the event point can only be seen when one generated a Horizontal Alignment Event Point List Report. It would be better also if the elevations can be seen earlier in the Event Points List Table
9 months ago in Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

Civil Preferences Location

For the OpenCivil products, it would be nice to have the civil preferences folders that are located under C:\Users\<username>\AppData\Local\Bentley\OpenRoadsDesigner\<version>\prefs (both the civil and civil_commands folders) use the b...
5 months ago in OpenRail Designer / OpenRoads Designer / Workspace 0 Future consideration

Collision-Free cross section annotation

​​There appears to be a feature in OpenRail and previously was in InRoads where you could specify in the Annotation Group to have the annotation shift if there was an overlap with another annotation but can't find the same feature in OpenRoads Des...
over 2 years ago in Annotation / OpenRail Designer / OpenRoads Designer / OpenSite Designer 1 Future consideration

Need Named Boundaries or Multi-Point Cross Sections that can turn for secondary alignments

Currently, when secondary alignments are used, the cross sections are always based perpendicular to the primary alignment. We need the ability for named boundaries (or some other means of creating multi-point cross sections) to understand when sec...
about 2 years ago in Drawing Production / OpenRail Designer / OpenSite Designer 4 Future consideration

[Terrain] Flow arrows with slope percentages

Need ability to toggle slope percentage annotations above/below the flow arrows on terrains. This will help with design and analysis. An option could be added in the flow arrow properties, please refer to the attached snapshot.
about 1 year ago in OpenRail Designer / OpenRoads Designer / OpenSite Designer / Terrain 1 Future consideration