Need Support? Let’s guide you to the right answer or agent.

OpenTunnel Ideas Portal

ADD A NEW IDEA

Functional Areas

Showing 1291

Add option to HorizontalAlignmentCheckIntegrity.xsl report to ignore angular differences for PIs with no curves.

In the InRoads Check Integrity command, the command would report "OK" for any PIs that did not have curves. We would like the ORD check integrity reports to not report issues at a PI if there are no curves present.
over 1 year ago in OpenRoads Designer / Reports 0 Future consideration

Display transparent catchment boundary at the cursor when relocating an inlet.

Enable the user when relocating a catch basin to view the catchment boundary as the inlet location is adjusted. Thus, acting as a dynamic and transparent view of the catchment boundary for the inlet at the new location. This will simplify the work...
about 2 years ago in Drainage and Utilities / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

Superelevation Frame Annotation can annotate the 0% cross slope location

As part of the profile superelevation annotation, the annotation currently cannot annotate the location where the superelevation is 0%. This would be helpful to show in plans and for designers to easily see the station this point is at.
almost 2 years ago in Annotation / OpenRail Designer / OpenRoads Designer 1 Future consideration

Add the ability to target drainage structures

I'd like for a corridor to be able to target drainage structures. When I have an RCB or end section the corridor end section should be able to target those things for the model to be accurate. I can fake it by adding surfaces on the structure to t...
4 months ago in Modeling / OpenRoads Designer 0 Future consideration

Ability to Export Profile Run To Consider Node Length

Currently it is not possible to export the alignment and profile from Profile Run with same station as it considers the nodes in the profile. We can select the conduit and export it, but this would be actual conduit length not the center to center...
19 days ago in Drainage and Utilities / Import/Export / OpenRail Designer / OpenRoads Designer 1 Needs review

Template Display Rules for Null Points

Template Display Rules are very powerful and widely used in corridor modeling workflows. However, Display Rules are only available for components. We would like to extend this functionality to the Null Points. This would open new possibilities for...
over 2 years ago in Modeling / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

Allow Cross Section Navigator to work in read-only mode

The XS Navigator tool's full functionality is contingent upon users having file read/write access. This requirement seems excessive for reviewers who primarily need read-only access. I suggest revising the tool to accommodate reviewers with read-o...
10 months ago in OpenRail Designer / OpenRoads Designer / User Interface 0 Future consideration

ROW Workflow - Functionality in Connect equivalent to Geopak COGO input files

In order to comply with the Kansas State Board of Technical Professions "Minimum Standards", the Kansas Department of Transportation is asking for an enhancement to OpenSite Designer CONNECT Edition software for Right of Way workflows as follows: ...
over 2 years ago in OpenRail Designer / OpenRoads Designer / OpenSite Designer / Survey 6 Future consideration

Disable Point Controls Rather than Delete When Control Can't Be Found

Currently when the control - profile, alignment, feature - can't be found due to a deletion or reference detachment, the corresponding point control(s) is removed from the corridor. Considering that these events may occur inadvertently and not dis...
over 2 years ago in Modeling / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

Add a Geometry Connector tool for Vertical Geometry

Cuurently OpenRail implements a tool called Geometry Connector (similar to Multiple Horizontal element Regression Analysis in Power Rail Track). However similar geometry tool is not available for vertical geometry calculations. It would be possibl...
about 2 years ago in Geometry 1 Future consideration