When setting a point control reference in InRoads, it would automatically set the limits to the start and end of that feature. I would like to see this as an option instead of only being able to lock to the start or end of the corridor/alignment. ...

We would like to see a search bar or Filter for Feature Definitions. Our Featue Definitions are numbering in the hundreds if not thousands and as much as we try to organize it in a way that makes sense some are still hard to find.

It would be super helpful if I didn't have to search two different property menus for where to change specific properties. If the general properties menu and the ORD DU properties menu could be more centralized into one properties menu, this would...

Currently, LEAP Concrete reports required interface shear reinforcement values for both a smooth and a roughened condition. It also flags a design as not passing if either minimum is not met. If I know I have a roughened girder, I should be able t...

Currently the Description Separator is in the Survey Settings. Description Separator and Attribute Separator should be in the TIW. (Text import wizard). I will like a prompt to set the Description Separator just before you import a file.

In SS2 InRoads Roadway Modeler we used to be able to see component slopes and widths in a pop-up window when hovering on components. This allowed us to quickly test that new point controls (or parametric constraints) were working as intended. It's...

A particular state DOT utilizes an integral abutment detail where the end diaphragm over the abutment is cast as part of the deck slab pour to encapsulate the ends of the steel girders or PPC I-beams (eliminating abutment joints). This end pour ov...

Introduce standardized functionalities across similar dialog boxes. For example, the Target Alias dialog allows you to directly select terrains whereas the Create Complex Terrain Model dialog has a button to use Selection Set. The dialogs should h...

We need a snap setting to be active by default for self-attached attachments created by 3d cuts in profiles. Currently, the snap setting is set to off by default, which forces us to always turn it on manually in the attachments dialog, which is an...

When using the "Create 3D By Slope To Target Tool " the only way to Trim/Extend the resulting linework is to manipulate the start/stop station which is very cumbersome. It would be much more intuitive if a Trim/Extend arrow head (similar to geomet...