Need Support? Let’s guide you to the right answer or agent.

OpenTunnel Ideas Portal

ADD A NEW IDEA

All ideas

Showing 1524

GenerativeComponents - Feature Definition tool Node

Special Node/Option for Full recognition (reading civil information) and creation of Feature Definitions in GenerativeComponents. GC & Civil Packages would benefit greatly if we could automate the creation of Civil Lines (2D/3D) for subsequen...
over 1 year ago in Modeling / OpenBridge Modeler / OpenRail Designer / OpenSite Designer / OpenTunnel Designer 0 Future consideration

ITL Copy Components

Add ability to copy points, components and sets of components
about 1 year ago in Modeling / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Needs review

Selection of named boundary with different associations

TxDOT likes to see driveway P&P’s side by side on a single sheet (see attached example), and when the workspace didn’t have a sheet seed that accommodated this type of configuration we created one ourselves. The main issue is placing both driv...
about 1 year ago in Drawing Production / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

Ability to print without needing to go through named boundaries

We were previously able to drop a border cell in any file to easily be able to print and now it is not
about 1 year ago in Drawing Production / OpenBridge Designer / OpenBridge Modeler / OpenRail Designer / OpenRail Overhead Line Designer / OpenRoads Designer / OpenSite Designer / OpenTunnel Designer 0 Already exists

Support for Partial-Depth Deck Panels

This is a must have feature for precast bridges.
almost 2 years ago in OpenBridge Modeler 0 Future consideration

Inserting the actual profile of reference adjacent profile

This is a missing feature on the Project Profile to Element as it is only accurate when two elements are actually parallel. We need some feature that will instantly copy/insert the profile of the adjacent element which is usually a reference dgn. ...
9 months ago in Geometry / OpenRail Designer / OpenRoads Designer 0 Future consideration

Needs ability to set RIM Depression Depth

Needs ability to add RIM Depression Depth with elevation (ground). Currently we can only set the Elevation (RIm) but not any depression value.
over 2 years ago in Drainage and Utilities / OpenRail Designer / OpenRoads Designer / OpenSite Designer 1 Future consideration

aerial transparency

When utilizing plan over plan sheets, the top aerial responds to transparency set in the design model, but the bottom one does not. Please reference the discussion on this Bentley forum. https://communities.bentley.com/products/road___site_design/...
almost 2 years ago in Drawing Production 0

Civil Labeler - multiple intersection points

I want to create a label that will be placed at the intersection of a corridor line and several drawn pattern lines. However, the Intersection placement method only allows for one selection and one other selection. You can't use a selection set. W...
almost 2 years ago in Annotation / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

Add option to create Mass Haul Diagram from End Area Volumes.

Currently the Mass Haul Diagram volumes are generated from 3D mesh volumes and the End Area Volumes report calculates the volumes from the cross section areas. Hence there is a difference between the Mass Ordinate values between the two reports. I...
over 1 year ago in OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration