Need Support? Let’s guide you to the right answer or agent.

OpenTunnel Ideas Portal

ADD A NEW IDEA

All ideas

Showing 1529

Surface Templates- Option to create top 3D linear element

Currently, when a surface template is applied there is not a 3D linear element created for the top linear feature. It would be useful to have the option to create the top 3D linear element.
over 1 year ago in Modeling / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

Prestressed Concrete Girder Beam End Cuts & Clips

It would be great if we could control the vertical end cut orientation of the concrete girders: Normal (as is) and Vertical (plumb to the world). Also, we often have to clip the corners of girders when bridges are on heavy skew. Would be nice to b...
over 1 year ago in OpenBridge Designer / OpenBridge Modeler 1 Planned

Plan Annotation by station range

It would be useful to have the ability to annotate only part of the horizontal alignment. There are situations where we need to have several different annotation groups along the alignment.
about 2 years ago in Annotation / OpenRail Designer / OpenRoads Designer / OpenSite Designer 1 Future consideration

Create a button/command that creates a linked 3D model associated with the active 2D model

When we create a new file we often start with a 2D seed with only one 2D model in it. We often would like to have a linked 3D model associated with that 2D model. It would be great to have a simple button that force creates the linked 3D model.
9 months ago in OpenRail Designer / OpenRoads Designer / OpenSite Designer / User Interface 0 Future consideration

ORD can't move new workflow to first

MicroStation can move a new workflow on first. But ORD can't move a new workflow on first.
almost 2 years ago in OpenRoads Designer 0 Future consideration

Analyze Point improvement to display slope in a vertical radius.

It is often necessary to check the slope in a specific point/section of a vertical curve, but this cannot be done right now with the "Analyze Point" tool. No matter where on the alignment I click the slope that displays is the slope of the first v...
3 months ago in Geometry / OpenRail Designer / OpenRoads Designer 1 Needs review

Facilitate successive volume calculations

Currently the simple calculation between 2 3D models is summarized between 2 comboboxes with a visual choice in a list of 3D models. If we have 60 models it becomes very difficult to make choices because the palette disappears after each calculat...
over 1 year ago in Analytics 2 Future consideration

Ability to customize Slopes between points symbology and ruled

When labeling site pavements slopes, the tool only allows for a pre-defined symbology (slope=X.XX% ->) and it`s a simple text.We use a different symbology, basically a arrow cell and a text between the two points.The abillity to customize the l...
almost 2 years ago in Annotation / Drawing Production / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

Analyze Volume Terrain model misses the old "Triangle Volume report" option

When using the "Analyze Volume Terrain model" tool the only way to save the result is to place a text in the dgn file. As in the legacy product (PowerCivil/InRoads) we need to be able to save a report (eg. using TriangleVolumes.xsl) ...it should b...
over 2 years ago in OpenBridge Designer / OpenBridge Modeler / OpenRail Designer / OpenRoads Designer / OpenSite Designer / Reports / Terrain 0 Future consideration

Support UNC paths and writing a conditional in the OrganizationSetting.cfg file

MnDOT would like to set a network location for the standard libraries. This way every user gets the current design. OpenRoads SignCAD does not currently support UNC paths or writing a conditional in the OrganizationSetting.cfg file. It seems illog...
about 1 year ago in OpenRoads SignCAD 0 Future consideration