Reference setting for saved view reference attachment to synchronize "settings from design model" synchronizes the level display state from View 1 of the view group that the saved view was created from (this is often the "Default View Group"). Whe...

When using the Create Drawing Dialog to cut sheets, Plan Mode, with One Sheet per DGN enabled, the sheet dgn files are named based on what is entered in the Sheet Model Model Name field. Add a field for Sheet DGN name. The DGN name needs to comply...

The "Export to IFC" tool only exports the default model, not the active one. This is a big problem with OR since in most cases, the default model is the 2D. So we have to have the 3D reference turned on for it to export our objects. We end up with...

Example would be for Pipe lengths. If a label is set to place the "designed" pipe length, but it needs to be changed to constructed pipe length. And that civil label has been used multiple times in multiple sheets. It would be great if when someon...

A user asked, "Why is it that upon closing cross cross-section navigator, users have to re-associate an alignment, pick a viewport to display the dynamic cross sections, and then data point inside this viewport to get the Cross Section Navigator p...

Develop a way to split up a bridge model into multiple smaller segments in separate dgn files to allow multiple designers to model simultaneously.

For now ORD Cross sections have limited capabilities compared to MS Clip volumes. Request is that ORD cross sections do inherit full capabilities of MS Clip volumes, including capability to define a thickness for point clouds and project the Point...

If you check the "Do not Show Again" box and press OK to the warning message in OpenRoads SignCAD 2023, then you can add additional panels to the file without the warning message displaying. However, closing and reopening the file will cause the m...

Circular eccentric nodes, like manholes, should have the ability to have a rotation point at the center of the structure and elevation reference at the center of the frame and cover.

In the Feature Definition Toolbar, there is a button to "Use Active Feature Definition" This should be enabled by default. When a users selects a feature definition from the list, they expect that is what will be used for civil elements.