Need Support? Let’s guide you to the right answer or agent.

OpenTunnel Ideas Portal

ADD A NEW IDEA

All ideas

Showing 1691

Sheet presentation of Drainage and Utilities nodes in plan view with annotation cells

When we initially stood up Storm and Sanitary, we had the center point presentation in plan view display a representative cell. I propose that we allow the placement through an element template of an annotative cell at the center of nodes to repre...
2 months ago in Drainage and Utilities / OpenRail Designer / OpenRoads Designer 1 Needs review

Create Turnout Profile

Currently, the workflow to achieve this is in general case (including canted track) where profile = lower rail elevation is : Create lower rail of branch line: horizontal offset create rails on main: create rails command Extend slope defined by ma...
2 months ago in OpenRail Designer / Turnouts/Crossings 0 Needs review

Geometric "intervals" (remove or hide)

When you are working with design you shouldn´t need to think about whether the elements you see on the screen are "real elements" or "intervals" - and it´s not so easy for the user to control if the program creates one or the other when you work. ...
5 months ago in Geometry / OpenRail Designer / OpenRoads Designer 0 Future consideration

Remove length restriction in offset geometry command

Please remove the restriction that makes it impossible to make the offsetted element longer than the base element. It is normally the direction that is important and the length can be edited afterwards. Otherwise add an opportunity to remove the r...
5 months ago in Geometry / OpenRail Designer 0 Needs review

Terrains Analyse Volume scenarios toolbar

Instead of a one time thing, create and save the comparison set in a toolbar table. If I want to run again I just need to hit a refresh button for the specifc set. When developing a project, keeping track of cut and fill volumes between design and...
almost 2 years ago in OpenRail Designer / OpenRoads Designer / OpenSite Designer / Terrain / User Interface 0 Future consideration

Cross Section Named Boundary Scan Criteria

Add option for scan criteria in models for upper lower limits like Geopak had. It could include wildcards to list levels/features to be included for the upper lower limits. We would rather not manually change level display, feature settings or cre...
over 2 years ago in Drawing Production / OpenRail Designer / OpenRoads Designer 1 Future consideration

Surface Template that allow holes

Surface template should allow the selection of any type of shapes, specially with holes. A tool to add new holes post creation would be wonderful too
over 1 year ago in Modeling / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

Verify Turnout

Use the Geometry Connector with start and end elements chosen as turnouts. The converged result gives a disconnection between the regression alignment and the turnout. You can only discover it by zooming in to the closest possible view. A "Verify ...
7 months ago in OpenRail Designer / Turnouts/Crossings 0 Needs review

Ability to switch the priority of other end conditions within the end condition editor as an override.

Currently there is no way to use end condition exceptions and as an override switch between other end conditions within a certain station range. A simple addition to the override feature where you could temporarily change the priorities of the end...
over 1 year ago in OpenRail Designer / OpenRoads Designer 0 Future consideration

Include terrain option for clearance in Xsection named boundary

Please include a terrain option for clearance in Xsection named boundary similar to the Profile named boundary.
over 2 years ago in Drawing Production / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration