In previous versions of SignCAD, there was a default checkbox for automatically saving sign inventory files alongside the .SGN file when saving sign files. This feature would be valuable to have alongside the other proposed sign inventory features.

Tap nodes are incredibly useful but do not allow for hydraulic modeling or for profile runs. I'd prefer to use tap nodes over transitions because they are easier to use and do not break trunklines into segments. This would help with profiles, pipe...

I am manually annotating cross sections (~90 total) due to the drawing model annotation tool not working properly. Therefore this idea came about after frequently using the "Note>Place Label" tool and these two feature names: XS Offset & XS...

Currently in the frame annotation (Is Top Frame) if the Annotation with Collision free option turned on have a negative bottom margin defined so that the leader start before the mainline leader ends, the mainline leader needs to be trimmed from th...

It would be nice to be able to limit the elevation callouts (and other callout types) within a station range if possible. I.E > when labeling EOP/curb through an intersection, using the Elevation - Along geometry labels the entire element and t...

This is useful to enable a) - checks to be carried out, b) - to identify possible conduits that require amending - to align with all others. This will enable consistent and accurate output data to be produced, that can be used to construct from.

OpenRoads Modeling > Terrain > Create > Additionnal Methods > Create Corridor Alternate Surfaces. Add an Toggle on/off option to create a Feature Boundary on each alternate surfaces based on the ends linear.

Would be nice if the non-indexed profile models and cross section models prevented users from being able to assign coordinate systems. Also would be nice if coordinate systems weren't able to be attached to sheet models either. Since coordinate sy...

Provide an option to enter girder properties for both the back span and fwd span if varying girder properties between back and fwd span When generating moments due to braking force, provide an option that distributes the moment divided by 10 and a...

If I have a pipe and I need to cut a cross section along the pipe, And that pipe has a bend in it, I can't use the 2 point method, I need one that allows for bends and twists and turns. If the annotation is based on the type/purpose then swapping ...