Want the ability to annotate every special point of the horizontal & vertical alignment with a number in sequence. You can veiw a sample of the profile annotation needed in the image below or in the PDF attached. This type of annotation is com...
about 2 years ago
in Annotation
0
Future consideration
Ability to Adjust Pull Down menu windows for example in Linear Feature Definitions or Component Feature Definitions
When remapping templates, it would be good to have the ability to see feature Definitions / Components anything really in a pull-down menu and be able to adjust it and it will keep that sizing under your user settings. Also, if we can have the abi...
about 2 years ago
in Workspace
0
Future consideration
Cell in GC will have additional properties for IFC
Placed cells with Generative components on alignment which have assigned item types as additional properties. Those properties will be later exported to IFC. Now the additional properties are not shown in GC only in ORD.
Manual Editing of Cant: Make it easier and allow it to be permanent.
The "ruled" cant tries its best to calculate appropriate values of superelevation. Usually, these end up being over-ridden for many reasons, good or bad. Turning off the rules in Cant editor allows manual editing, but it is very time consuming, "r...
Please add a variable MS_LEVEL_DO_NOT_OVERRIDE_DESIGN_LEVELS_IN_DRAWING that does what MS_LEVEL_DO_NOT_OVERRIDE_DESIGN_LEVELS_IN_SHEET does for sheets but for drawings
0
Future consideration