Need Support? Let’s guide you to the right answer or agent.

OpenTunnel Ideas Portal

ADD A NEW IDEA

All ideas

Showing 1224

Add Support for 3D Cut on Closed Alignments

Currently, The 3D cut does not work on the closed alignment's profile model. This is required specially in the case of Roundabouts. We can not create a 3D cut on the Roundabout profiles.
10 months ago in Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

Design Footing with sides that are parallel to the column sides

Some tight geometric conditions require a this scenario
over 1 year ago in OpenBridge Designer 0 Future consideration

It would be beneficial to allow drainage designers to use graphical elements in combination with terrains to define time of concentration components

Currently, in order to determine one of the components of the Time of Concentration (Tc), ORD DU users have to jump completely out of the 'Catchment Properties' interface to determine the length and slope of the Tc element (since once you are in t...
over 1 year ago in Drainage and Utilities 0 Future consideration

Create 3D by slope to terrain needs to have the option for the fill slope to be positive and vise versa for cut slope

When projecting a line to a terrain currently the only option for fill is down and cut is up. This needs to be a user selectable option. There are many cases where the proposed surface is above the existing ground yet the fill projection needs to ...
over 1 year ago in Modeling / OpenRail Designer / OpenRoads Designer / OpenSite Designer 2 Future consideration

Allow the use of equations when creating civil labels

We would like to be able to create a civil label that labels the elevation of a terrain model. We would like this label to include both a top of curb elevation and automatically do the math to subtract a set distance from that elevation so that it...
10 months ago in Annotation / OpenBridge Designer / OpenBridge Modeler / OpenRail Designer / OpenRail Overhead Line Designer / OpenRoads Designer / OpenSite Designer / OpenTunnel Designer 0 Future consideration

Store vertical/horizontal alignment of low points

A tool existed in Geopak that could pick out the low point of a cross section to the left and right of centerline and construct horizontal and vertical alignments from that. This essentially automated the creation of a ditch profile along an entir...
over 1 year ago in Modeling / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

Profile by best fit - Curve radius

Request to introduce the ability to create a profile by best fit by defining the radius of the arc rather than its length?
over 1 year ago in Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

Add ability to delete multiple template point's constrains at once while editing the Transition Midpoint

While editing the Transition Midpoint, we need to delete both the constraints of multiple template points. currently we can delete the constrains of point one at a time. This can become tedious process when there are lot of points of which both th...
over 2 years ago in Modeling / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

Vertical curves/kvalues to report direction as positive/negative

Handing of vertical curves in reports/table editor is always positive in the reports. Geometry exports are used by Construction Teams, as part of the Approved for Construction design pack. Horizontal curves have a handing convention - +ve = RH cur...
10 months ago in OpenRail Designer / Reports 1 Future consideration

Include OpenRoads Designer Standards (Feature Definitions, Symbologies, Annotation Groups etc.) When Importing Feature Definition .dgnlib into another design model

It would be very helpful if "All" the OpenRoads Designer Standards (Feature Definitions, Symbologies, Annotation Groups etc.) would come through when Importing a Feature Definition .dgnlib into another design model. Currently, if you import one mo...
over 2 years ago in Import/Export 0 Future consideration