Need Support? Let’s guide you to the right answer or agent.

OpenTunnel Ideas Portal

ADD A NEW IDEA

All ideas

Showing 1703

Utility Overhead Conduits- Need Vertical Sag

Can the Overhead conduits be set to apply "sag " curves for models in 3D? which means, we will need to include vertical curves when placing them between 2 nodes (eg. poles); In a real world, the conduits typically have some sag, and not as straigh...
almost 2 years ago in Drainage and Utilities / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Needs review

Ability to Hide & Isolate all elements belonging to specific Corridors/Linear Templates

In Openbridge you can untick a Bridge in Explorer and it will hide that bridge in both 2d and 3d models. In OpenRoads, this functionality is very much needed for Corridors and Linear templates (similar to what we have for Feature Definitions). We ...
almost 3 years ago in Modeling 1 Future consideration

Profile Superelevation annotation based on Crossfall to a Linear feature

For almost all our projects we require very precise crossfall transitioning at tie-ins to existing and situations at ramps where we project crossfall from one carriageway to another. It is not practical for us to report crossfall and copy the valu...
almost 3 years ago in Drawing Production 0 Future consideration

Copy Lines Drawn in Profile Window to Other Profile Window

In order to correctly design Crossovers, profile information needs to be sketched out between profile windows. This is very difficult without the ability to draw lines in a profile window and then copy them to a profile window for another alignment.
almost 3 years ago in OpenRail Designer 2 Future consideration

Open profile from profile view

While I am in a profile view, I would like to be able to open a new profile from a different horizontal without having to activate the 2D view. It is a small thing but would be nice.
over 2 years ago in Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer / User Interface 4 Already exists

Linking multiple cant alignments with a dependency into a referenced container model

My company plans to undertake large route alignments, but broken down into smaller alignment sections for different contract areas. Currently, we are 'stitching' the smaller sections into a routewide federated model by using Single Offset Entire E...
over 2 years ago in CANT / OpenRail Designer 2 Future consideration

PMM non-linear springs

We would like to ask a PMM non-linear spring for modeling Plastic Hinges for reinforced-concrete Columns. This PMM springs are used for modeling the Moment-Rotation (M-R) behavior for different axial loads (P). The PMM spring should be able to cap...
12 months ago in Analytics / OpenBridge Designer 0 Needs review

GenerativeComponents - Feature Definition tool Node

Special Node/Option for Full recognition (reading civil information) and creation of Feature Definitions in GenerativeComponents. GC & Civil Packages would benefit greatly if we could automate the creation of Civil Lines (2D/3D) for subsequen...
almost 2 years ago in Modeling / OpenBridge Modeler / OpenRail Designer / OpenSite Designer / OpenTunnel Designer 0 Future consideration

Easy civil cell for turnout edition

Create an Easy civil cell for turn-out edition and turn-out annotation
almost 3 years ago in OpenRail Designer 0 Future consideration

Add option to create Mass Haul Diagram from End Area Volumes.

Currently the Mass Haul Diagram volumes are generated from 3D mesh volumes and the End Area Volumes report calculates the volumes from the cross section areas. Hence there is a difference between the Mass Ordinate values between the two reports. I...
almost 2 years ago in OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration