In placing drainage node to the carriageway or kerb/curb lines in 2D plan, it is useful to show the flow arrow from high point to low point for the drainage engineer. Currently, the flow arrow is only available in "Terrain", but not civil geometry...

This tool works for the branch geometry that is starting with a tunout. While creating the cant it applies the same cant value it read from main track geometry to the start of the turnout geometry. Also tool needs to have an option to change rotat...

Option to keep siding alignment start station in synch with mainline alignment as shown in the attached video

Ability to separate the annotation of curves and spirals for the rail cant. At present the Non-Linear setting is applying to both This is usefull to remove some clutter (especially where there is short elements like below;

Currently in annotation group, the back/ahead tangent line drawn at the PI only has the option for a fixed length. We would like the ability to draw back and ahead tangents the full length from PC to PI to PC. This could apply to both horizontal a...

In the Cant Editor, there is a tool called validate data which allows you to add in your design parameters and then check against the cant the Openrail has already automatically generated. although a good tool, i just think it would be better Open...

With Inroads Survey, whenever XYZ coordinates needed to be entered for a particular purpose, a screen-pick option was always available. (see attached image) This was extremely useful. However, with ORD, changing the XYZ coordinate of any points in...

You can name an element if drawn 1 at a time with tangents and arcs. But if you use Complex by PI you can't go back and name your elements to make it easier to report on your geometry.

In the Superelevation Editor, being able to add a point of reverse curvature on reverse parabolic transitions will help when trying to manually define/adjust points of 0% cross slope.

In the Superelevation Editor, adding a "crown removed" option to the Point Type list would help when trying to manually define/adjust anywhere there is 0% cross slope.