We need to be able to track alignment data to check sheet annotation. Would be very helpful to have an easy way to do this in sheets. Since an alignment or terrain would still need to be selected, the sheet scale shouldn't matter. This would work ...

Currently, the only way to update Annotation is to update ALL or one drawing model at a time. It would be very helpful to be able to select a station range to remove and then update in one action.

In Geopak, we had the ability to take individual alignments and create an overall alignment from a subset of alignments and it would hold the individual stationing for each alignment, creating station equations. There is no way to do this in ORD u...

The existing Locate Point tool using the Traverse and Radial methods functionally does something similar, but must have 180 degrees added manually to the deflection angles to get the absolute angle.

Whenever you have a Geometry and used shared line (e.g. Lots), There should be a tool to remove duplicate/overlapping lines. Its problematic if we use a special linestyle with gaps and when the two line on top of each other it will look like a sol...

I would like Geometry Points to support using parametric cells.

My state agency commonly uses gutters with a 4% cross slope. The maximum superelevation rate is 7%. The gutter slope stays at 4% in this situation. Spread does not compute in this scenario because "A depressed gutter must have a Gutter Cross Slope...

What I envision, would be the ability to define Math within a Text Favorite. So, let us say that "[[" would define the start of math in a text favorite. A text favorite could be created in that the value displayed, is math from element properties....

It would be nice to be able to export a drainage network into 2D linework that can be edited for plan sheets. Currently, we don't use our modeled files directly in our plan sheets as we cannot adjust the conduit line styles and it takes longer to ...

In order to comply with the Kansas State Board of Technical Professions "Minimum Standards", the Kansas Department of Transportation is asking for an enhancement to OpenSite Designer CONNECT Edition software for Right of Way workflows as follows: ...