Need Support? Let’s guide you to the right answer or agent.

OpenTunnel Ideas Portal

ADD A NEW IDEA

Functional Areas

Showing 1356

Provide Low Point/High Point Information in Profile Table Editor

Lost functionality that was available in Geopak. Helpful to meet specific locations when designing a profile, instead of storing the profile and reading the profile report, or hand calculation of the low and high points.
11 months ago in OpenRail Designer / OpenRoads Designer / User Interface 0 Future consideration

Please add support for DWG files on import or Attach function

I am using OpenRoads ConceptStation 2024, Tried to load the basic 2D dwg file as reference for a road design work, but system not allowed, current turnaround is convert dwg to dgn which is not best bet. Pease add support for DWG files on "import" ...
11 months ago in Import/Export / OpenRoads ConceptStation 0 Future consideration

Create corridor from reference feature

Our current standard workflow for roadway corridor modeling is to create a pavement corridor then a corridor for each end condition Rt and Lt. I have seen many others including some Bentley folks use this method. It would be big time saver to have...
over 2 years ago in Modeling / OpenRail Designer / OpenRoads Designer 2 Future consideration

It would be beneficial to allow drainage designers to use graphical elements in combination with terrains to define time of concentration components

Currently, in order to determine one of the components of the Time of Concentration (Tc), ORD DU users have to jump completely out of the 'Catchment Properties' interface to determine the length and slope of the Tc element (since once you are in t...
almost 2 years ago in Drainage and Utilities 0 Future consideration

Geometry - Copy Chain Parallel Command

There was a command in Geopak called Copy Chai n Parallel that was very useful in creating offsets of survey chains, and creating new points at constant delta elevations. We are looking for the same function to be added in OpenRoads Designer.
over 2 years ago in Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer 1 Already exists

Turn on/off elements in the main dgn will change on all the sheets.

It is expected to turn on and off elements in the container file and it will reflect those changes on all the profile sheet models.
almost 2 years ago in Drawing Production / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Already exists

Allow LFD substructure analysis with an LRFD Superstructure in LEAP Steel

When performing a superstructure replacement, it is common to design the proposed superstructure in LRFD but then analyze the existing substructure capacity in LFD. Currently with LEAP Steel, because the superstructure was designed in LRFD the sub...
almost 2 years ago in Analytics 0 Needs review

Create 3D by slope to terrain needs to have the option for the fill slope to be positive and vise versa for cut slope

When projecting a line to a terrain currently the only option for fill is down and cut is up. This needs to be a user selectable option. There are many cases where the proposed surface is above the existing ground yet the fill projection needs to ...
almost 2 years ago in Modeling / OpenRail Designer / OpenRoads Designer / OpenSite Designer 2 Future consideration

Store vertical/horizontal alignment of low points

A tool existed in Geopak that could pick out the low point of a cross section to the left and right of centerline and construct horizontal and vertical alignments from that. This essentially automated the creation of a ditch profile along an entir...
almost 2 years ago in Modeling / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

Profile by best fit - Curve radius

Request to introduce the ability to create a profile by best fit by defining the radius of the arc rather than its length?
almost 2 years ago in Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration