Need Support? Let’s guide you to the right answer or agent.

OpenTunnel Ideas Portal

ADD A NEW IDEA

Functional Areas

Showing 1147

It would be benefitial to allow drainage designers in ORD Drainage to use graphical elements in combination with terrains to define time of concentration components.

Currently, in order to determine one of the components of the Time of Concentration (Tc), ORD DU users have to jump completely out of the 'Catchment Properties' interface to determine the length and slope of the Tc element (since once you are in t...
about 1 year ago in Drainage and Utilities 0 Future consideration

Allow modeling of Pier Segments with different cross section

For Segmental Bridge Modeling, Pier caps segments typically have diaphragms built in and are a different cross section than the other typical segments. OBM should allow this to be modeled.
about 2 years ago in Modeling / OpenBridge Designer / OpenBridge Modeler 0 Future consideration

Add option to use only centerline radius for superelevation calculations

Provide an option or new method to use the centerline radius (instead of inside lane radius) for divided highways that use a Crown pivot method. The Divided Inside pivot method already does this for divided highways that pivot about the inside lan...
about 2 years ago in OpenRail Designer / OpenRoads Designer / Superelevation 0 Future consideration

Graphical Results for Cross-Frames/Diaphragms

In the LEAP Bridge Steel analysis dialog box can there be an axial force diagram, with the cross-frames/diaphragms visible?
7 months ago in User Interface 0 Needs review

Need the ability to define sequence number other than at the end of the filename

We have a standard naming convention that uses sequence numbers which are in the middle of the filenames. This has been our standard for over twenty years. Additionally, we require each sheet to be in a separate file for multiple flexibility and a...
7 months ago in Drawing Production / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

Allow entering a degree of curve (d 00^00'00") as the Radius of the Alignment Table Editor.

When creating curves, an ORD user is allowed to enter a degree of curve (d 00^00'00") as the Radius. Put the same functionality in the Alignment Table Editor.
7 months ago in Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

Turn on/off elements in the main dgn will change on all the sheets.

It is expected to turn on and off elements in the container file and it will reflect those changes on all the profile sheet models.
about 1 year ago in Drawing Production / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Already exists

Coincident Sheets with Drawing Boundary

Please add the option to automatically assign coordinate systems to drawing and sheet models based on the design models and to place the sheets coincidently even when they contain drawing boundaries. Right now, we cannot create georeferenced pdfs ...
7 months ago in Drawing Production / OpenRail Designer / OpenRoads Designer / OpenSite Designer 2 Will not implement

Allow LFD substructure analysis with an LRFD Superstructure in LEAP Steel

When performing a superstructure replacement, it is common to design the proposed superstructure in LRFD but then analyze the existing substructure capacity in LFD. Currently with LEAP Steel, because the superstructure was designed in LRFD the sub...
about 1 year ago in Analytics 0 Needs review

Create 3D by slope to terrain needs to have the option for the fill slope to be positive and vise versa for cut slope

When projecting a line to a terrain currently the only option for fill is down and cut is up. This needs to be a user selectable option. There are many cases where the proposed surface is above the existing ground yet the fill projection needs to ...
about 1 year ago in Modeling / OpenRail Designer / OpenRoads Designer / OpenSite Designer 2 Future consideration