If ditches do become channel features, KYTC would need channels to then be able to attach to other node types besides headwalls since we have many conditions and locations where they outlet into inlets of various types.
Users often make changes to the different fit options in the Dynamic XS view that are not persisted when the file is closed or a section via datapoint is issued (Fit Section / Center Backbone / Center on Current Offsets). It defaults back to the F...
While I am in a profile view, I would like to be able to open a new profile from a different horizontal without having to activate the 2D view. It is a small thing but would be nice.
Flood Volumes - Surface analysis between three surfaces
It would be beneficial to have the ability to specify surface math logic - Above Existing, Below Proposed, and Below "Floodplain" (variable plane) to get good floodplain volumes.
Selection of named boundary with different associations
TxDOT likes to see driveway P&P’s side by side on a single sheet (see attached example), and when the workspace didn’t have a sheet seed that accommodated this type of configuration we created one ourselves. The main issue is placing both driv...
Linking multiple cant alignments with a dependency into a referenced container model
My company plans to undertake large route alignments, but broken down into smaller alignment sections for different contract areas. Currently, we are 'stitching' the smaller sections into a routewide federated model by using Single Offset Entire E...
New Variable to Control XSEC View Exaggeration Separate from Profile View Exaggeration
Consider adding a set of variables to control XSEC view exaggeration and default exaggeration separate from profile view exaggeration. This would be similar to how there is a separate set of variables for super exaggeration. Suggested variables wo...
The Feature Defintion toolbar - a proposal for improving this function
Feature Definition Toolbar
A proposal for improving/expanding this feature
Choosing Feature Definitions is a frequently used feature in OpenRoads Designer. Especially in urban projects, switching between pavement types, curbs, placing signs, s...
Allow for Hydraulic calculations and profile creation while using tap nodes
Tap nodes are incredibly useful but do not allow for hydraulic modeling or for profile runs. I'd prefer to use tap nodes over transitions because they are easier to use and do not break trunklines into segments. This would help with profiles, pipe...