Civil Labeler - XS Label height difference between centerline and curb or other key-point
We need ability to label height difference between centerline and curb or other key-point in our type XS. Or ability to label curb or other key-point height relative to centerline.
In the regression points table, there is no way to sort the regression points using stationing. It means that if points are not named so that you can order by the name, it becomes difficult to navigate and understand the table. Regression points b...
The labels for the ST, TS, CS, and SC points are in the lower part of the profile and are in offset with reference to the horizontal geometry band (as seen in the photo below wherein the radial offset is referenced from the geometry band). I think...
I noticed that template ranges can overlap and there is no obvious indication that this is occurring. Ideally over lapping station ranges should highlight in red to draw attention to it.
ONE DIALOG BOX TO MAKE SETUP. SO YOU CAN SET ANNOTION GROUP, FEATURE SYMOLOGIES, FEATURE DEFINITIONS, ELEMENT TEMPLATE AND SET LEVEL OF TEXT FOR AUTOMATIC ANNOTATIONS. REALLY CUMBERSOME TO HAVE TO GO TO SO MANY OTHER PLACES TO SETUP FOR ONE CODE
There needs to be a better way to understand the relationships between elements and reference files that are created by snap rules and constraints.
This improvement would use graphic symbols (construction elements) to represent constraint relationships in plan view. For horizontal elements that are snapped, there are the snap glyphs that show that there is a relationship, but there is not a w...
You can name an element if drawn 1 at a time with tangents and arcs. But if you use Complex by PI you can't go back and name your elements to make it easier to report on your geometry.
0
Future consideration