Need Support? Let’s guide you to the right answer or agent.

OpenTunnel Ideas Portal

ADD A NEW IDEA

OpenRail Designer

Showing 971

Connection Region in Bottom of Node

The current connection region of drainage nodes are available for the side faces of node only. The software should allow the connection region of pipe/conduit from the bottom of the node.
about 1 year ago in Drainage and Utilities / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

Profile projection tools for crossfall relative to Target element

In legacy software, we had the option to either project crossfall from one element to another relative/normal to the reference element or relative/normal to the target element. We do not seem to have this functionality in ORD currently (although t...
about 2 years ago in Geometry / OpenRail Designer / OpenRoads Designer 0 Future consideration

Auto-annotate parametric constraints, template transitions, point controls, superelevation

On road construction plans we need to label/annotate change points. We need to label where changes (lane width, superelevation transitions, side slope transitions, component start and end points, etc. ) from the “default” condition happen. The sof...
about 2 years ago in Annotation / Modeling / OpenRail Designer / OpenRoads Designer 1 Future consideration

Project Multiple Profiles onto one grid

It would be beneficial to project multiple profiles that are parallel to each other in one profile grid. For instance, one for Left front face of a curb, another for Construction Centerline, and another for Right front face of curb.
about 1 year ago in Modeling / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Planned

IFC: ability to use ACS origin as basepoint

When working with georeferenced file (UTM) define a point with ACS to be the 0,0,0 for the ifc. Architeture usually use a local project reference, we (infra) work on the UTM coordinates.The ifc Georeferencing would come from the UTM, but its basep...
over 1 year ago in Import/Export / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

Apply Surface Template by Selection Set

I would like to be able to apply a surface template to multiple terrain models at once, either by a previously-selected selection set, or by selecting one or more terrain models within the tool itself. In the attached image I would like to apply t...
almost 2 years ago in Modeling / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

Calculating design speed from CANT

Add ability to create speed table based on minimum-maximum cant/cant deficiency and curvature.
about 2 years ago in OpenRail Designer 0 Future consideration

Tabular profile annotation to include speed table values

As a light rail design engineer I want to produce profiles with a lot of information to be able to check a maximum amount of information on a single document.On critical information for light rail design is the maximum speed. This is because light...
about 2 years ago in Annotation / OpenRail Designer / OpenRoads Designer 1 Future consideration

"Curve Set" text favorite annotation should annotate entire curve set

Under the Curve Set option under Location, an option for Spiral Left Middle, Spiral Right Middle, Curve Left Middle, Curve Right Middle needs to be added. Ability to annotate the Middle of a Spiral and/or Curve within a Curve Set. These options ne...
about 2 years ago in Annotation / OpenRail Designer / OpenRoads Designer / OpenSite Designer 1 Future consideration

Provide Low Point/High Point Information in Profile Table Editor

Lost functionality that was available in Geopak. Helpful to meet specific locations when designing a profile, instead of storing the profile and reading the profile report, or hand calculation of the low and high points.
2 months ago in OpenRail Designer / OpenRoads Designer / User Interface 0 Future consideration