Need Support? Let’s guide you to the right answer or agent.

OpenTunnel Ideas Portal

ADD A NEW IDEA

OpenRail Designer

Showing 1130

Incorrect arc radius for turnout outer curve switch.

For turnout annotation, we need to add turnout with LLS Extension from the library. I know that it is possible to add LLS radius value for a defined curved turnout in the library, but for a complex project where there are a lot of curved turnouts ...
10 months ago in OpenRail Designer / Turnouts/Crossings 0

No subtraction of sleepers from ballast in corridor report

Corridor report does not subtract the volume of sleepers we added to the model from the ballast. I propose to add in the next version of ORD the possibility to subtract in the ballast the added sleepers.
10 months ago in OpenRail Designer / Reports 0 Future consideration

No possibility to set the lower limit height of the profile

When creating profiles using ,,Named Boundary”, I cannot set the lower height limit of the profile. I propose to add in the next part of ORD setting the lower height limit if we want to make one drawing sheet from profile. This would help with the...
10 months ago in Drawing Production / OpenRail Designer 1 Already exists

Display A parameter (not Length) after using "Create Civil Rule Feature" option.

When I create an alignment with curves using A parameter and when I select this alignment "A parameter" will be properly displayed. Then when I "Remove Rule" and use "Create Civil Rule Feature" tool, A parameter will be replaced with "Length".
over 1 year ago in Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

Best Match Field Code Option

In ORD 10.11 and beyond the Best Match Field Code Option is now a drop-down of the following: Match exact: Feature Must equal an Alpha Code, only exact matches. For example if there is a Feature Definition with Alpha Code set to AP (Asphalt Paveme...
10 months ago in OpenRail Designer / OpenRoads Designer / OpenSite Designer / Survey 0 Future consideration

Create multiple long sections/profiles in the same model space

When creating profiles/long sections for track vertical geometry, ORD creates an individual sheet view and model view for each sheet. This creates a large amount of work when trying to bulk annotate or export long sections for drafting. It would b...
over 1 year ago in Drainage and Utilities / Drawing Production / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

Additional Shoulder Rollover Slope Rows (3D Modeling - Templates)

I would like to make a suggestion on an improvement to template design for 3D Modeling in ORD. The Rollover values tool in superelevation template design is incredibly helpful, as it saves time by calculating the proper shoulder super rates accord...
over 1 year ago in OpenRail Designer / OpenRoads Designer / Superelevation 0 Future consideration

Modify default Height/Depth of a Node

In current version we do not have flexibility to change height/depth of a node from default 5.25 feet. At times we need lesser deep Nodes which does not require more than 1 or 2 feet of cover from soffit of conduit.
over 2 years ago in Drainage and Utilities / OpenRail Designer / OpenRoads Designer / OpenSite Designer 4 Already exists

Provide Low Point/High Point Information in Profile Table Editor

Lost functionality that was available in Geopak. Helpful to meet specific locations when designing a profile, instead of storing the profile and reading the profile report, or hand calculation of the low and high points.
10 months ago in OpenRail Designer / OpenRoads Designer / User Interface 0 Future consideration

Add an ExtendLine Code to Survey

This code would be similar to the DIST command, except it would allow the crews to add a taped distance to the last segment of a figure, which would extend that segment by that value. It would be similar to a DIST commend except instead of turning...
over 1 year ago in OpenRail Designer / OpenRoads Designer / OpenSite Designer / Survey 0 Future consideration