Similar to the custom tools for available for stiffeners and cross frames for steel built up or rolled shape beams, OBM needs to add tools for adding these to steel tub/U beams

Some of the older designers will recall the display "Colour-Coded Slopes" within InRoads, where DTM triangles could be shaded a single colour based on their resultant grade. As per the laws of geometry, one triangle could only be assigned one colo...

At the moment, you run Place Node, then set the type of node by picking a feature definition. However, you normally know what type of node that you want to place, such as a manhole for example,so it would be more intuitive if the ribbon contained ...

Currently the Mass Haul Diagram volumes are generated from 3D mesh volumes and the End Area Volumes report calculates the volumes from the cross section areas. Hence there is a difference between the Mass Ordinate values between the two reports. I...

Currently, when importing text files to fieldbooks the directory opens in the last used directory. It would be useful to control this behavior so that it can open in the directory where the active DGN is located. This can function similar to the c...

When performing a superstructure replacement, it is common to design the proposed superstructure in LRFD but then analyze the existing substructure capacity in LFD. Currently with LEAP Steel, because the superstructure was designed in LRFD the sub...

OpenRoads should have a Command that place a line between two imported points (.asc, .crv, .txt file) V8i does have a command that will place a line between two imported points. After importing the points into the drawing, you click on the "line c...

OpenRoads uses different types of file open dialogues throughout the program. The first type allows the user to paste a file address directly into the navigation bar. The second type does not allow the user to paste the file address and forces the...

We're using ORD version 2023, and the Civil Reports browser allows us the option to export to xml, html, doc, and xlsx file formats. We used to have a function that allowed us to save as a txt file, which we could change the extension to csv so it...

A tool existed in Geopak that could pick out the low point of a cross section to the left and right of centerline and construct horizontal and vertical alignments from that. This essentially automated the creation of a ditch profile along an entir...