Could we edit the values in the sheetseed.dgnlib rather than having to delete and start over. We can see the Civil properties and standards change and evolve could there be a way to let an admin make changes to the values. Example I want to change...

We need an item type civil expression for offset strings from corridor strings (lines created by template points) providing start / end station in respect of that corridor alignment. Currently alignment name needs to be specified manually to the e...

Currently Corridor Vertical/Both Point Controls link the the specific Vertical Profile and when these get deleted, the Point Control is removed without warning. An option to set this point control to always use the Active Profile would allow this ...

In OpenRail Designer, unable to output the direction information when comparing geometry points to a baseline alignment. In Bentley Rail Track we were able to create clearance reports that included the direction. It appears OpenRailDesigner's repo...

Support use of cell definitions for sleeper placements. Long sleeper sets placed at turnout locations, have variable width so these will still be using existing box shaped sleepers but normal sleepers will be using the cell based definitions. This...

Template in Openroads conceptstation must have benching option as one of the types in end-conditions.

Currently when defining the horizontal earth loading on an abutment, the only option is to have a triangular loading from top to bottom. The "Mag2" input box (for the load magnitude at the top of the load) is set at 0, greyed out, and cannot be ed...

Actually H+V+Cant can be only achieved through XML export/import.Turnouts are lost. It could help and simplify to have a command to copy an alignment from a file to another. Similary than what is happening when creating a civil cell, it would be g...

Unlike BRT, ORD does not allow defining different cross-section outlines for the front, middle, and rear of a vehicle. This capability is critical for accurate clearance assessments, especially for vehicles with varying geometry (e.g., tapered cab...

Requirement is to annotate horizontal length of straight on profile (station end - station start). It is available in frame annotation but not along linear so annotations don't match. Only the slope length can be annotated along the linear