Need Support? Let’s guide you to the right answer or agent.

OpenTunnel Ideas Portal

ADD A NEW IDEA

Applications

Showing 116

Approach Slab Line Offset

Currently the approach slab line uses an offset distance to place it. that offset value just shifts the line that distance along the alignment, which is not what we want especially on curved bridges. That offset distance needs to be a copy paralle...
almost 2 years ago in OpenBridge Designer / OpenBridge Modeler 0 Needs review

RM Bridge Envelopes for Shell Forces

I would like to start using RM Bridge with shell elements for transverse analysis, however, I have just found out that currently it does not provide envelope results for shell forces, this is an essential tool for live load transverse analysis.
over 1 year ago in OpenBridge Designer / OpenBridge Modeler / Reports 0 Needs review

Add the ability to calculate spread on two sides of a median barrier inlet

There are tens of thousands of barrier inlets on barrier medians throughout the US. Spread needs to be calculated on both sides, with the overall flow being added to the storm sewer system. Currently, the only way to do this is to create to halves...
6 months ago in Drainage and Utilities / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Needs review

Display existing and proposed track intervals on long section tables

It would be useful if existing and proposed track intervals (6fts) could be displayed automatically in the tabulated data of a profile for a drawing.
6 months ago in Drawing Production / OpenRail Designer 0 Needs review

Place 1 Cross Section per Sheet (or other predefined number of cross sections)

We want to place only one cross section per sheet so that once a pdf is created, the user can flip through the pdf pages quickly and each cross section appears in the same spot. We can sort of trick this by changing the spacing, but it would be mu...
over 1 year ago in Drawing Production / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Needs review

Allow Conduits from different "families" to connect to the same node.

Add support for nodes that accept multiple types of conduit families.
over 1 year ago in Drainage and Utilities / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Needs review

Utility Overhead Conduits- Need Vertical Sag

Can the Overhead conduits be set to apply "sag " curves for models in 3D? which means, we will need to include vertical curves when placing them between 2 nodes (eg. poles); In a real world, the conduits typically have some sag, and not as straigh...
over 1 year ago in Drainage and Utilities / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Needs review

Allow LFD substructure analysis with an LRFD Superstructure in LEAP Steel

When performing a superstructure replacement, it is common to design the proposed superstructure in LRFD but then analyze the existing substructure capacity in LFD. Currently with LEAP Steel, because the superstructure was designed in LRFD the sub...
over 1 year ago in OpenBridge Designer 0 Needs review

Hide underground and above ground pipes and equipment

Using OpenSite Designer, is there a way to hide items, i.e. pipe, valves, and equipment, below a surface? These components are on multiple elevations above and below this surface. All components are on the same level, i.e., WATER. Client does not ...
about 1 year ago in Modeling / OpenSite Designer 2 Needs review

RM Bridge update to use the correct AASHTO reduction factor for reinforced/prestressed concrete based on tensile strain in reinforcing at ultimate limit state.

The current RM bridge ultimate capacity calculations allow for material reduction factors only, which are not used by AASHTO for reinforced and prestressed concrete. AASHTO concrete reduction factors for flexure and P-M capacities are based on the...
about 1 year ago in OpenBridge Designer 0 Needs review