Need Support? Let’s guide you to the right answer or agent.

OpenTunnel Ideas Portal

ADD A NEW IDEA

Applications

Showing 1524

Volumetric Meshes created as Scalable Meshes

For large scale projects, earthwork volumetric meshes cause considerable deficits in navigation performance due to the high count of vertices and faces to be calculated with each navigational operation. Use of scalable meshes for these components ...
3 months ago in Modeling / OpenRail Designer / OpenRoads Designer 0 Future consideration

Include column and shaft controlling service loads (RCPIER/LEAP)

When designing drilled shafts, there is no option to display controlling shear and moment loads (bottom of column). This is needed for the geotechnical engineer on designing th drilled shaft. For column design, it is sometime useful to also show c...
3 months ago in OpenBridge Designer 0 Future consideration

Template (ITL): add parameters for component length, spacing and individual

It could be useful for different purposes to be able to create component meshes of defined length (construction, pre cast slab). I suggest to add at least 3 parameters to any component: length of the component: the question is then, where to measu...
3 months ago in Modeling / OpenRail Designer / OpenRoads Designer 0 Future consideration

Ability to change the bridge type after creating the bridge in OBM

Being able to change the superstructure type after the deck, substructures, approaches have already been modeled. Currently once you select the Bridge Type it locks you into that superstructure type and any work you complete under that bridge type...
6 months ago in OpenBridge Modeler 0 Future consideration

Calculating design speed from CANT

Add ability to create speed table based on minimum-maximum cant/cant deficiency and curvature.
about 3 years ago in OpenRail Designer 0 Future consideration

Tabular profile annotation to include speed table values

As a light rail design engineer I want to produce profiles with a lot of information to be able to check a maximum amount of information on a single document.On critical information for light rail design is the maximum speed. This is because light...
about 3 years ago in Annotation / OpenRail Designer / OpenRoads Designer 1 Future consideration

Regression: add a "Remove regression points" command both for H and V regression line

We can add points to regression line but we can't remove points from regression line.We can ignore but it is not good management especially if you added a wrong point to the regression line that must be added to another regression line. Because th...
about 3 years ago in Geometry / OpenRail Designer 1 Future consideration

Allow the use of multiple Horizontal Feature Constraints in Point Properties

The ability to target multiple Horizontal Feature Constraints for a template point and set priority on those individual Features. Similar to Target Aliasing.
over 2 years ago in Modeling / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

enhance ORD Cross section to have same capabilities as Clip Volumes (for Point clouds in particular)

For now ORD Cross sections have limited capabilities compared to MS Clip volumes. Request is that ORD cross sections do inherit full capabilities of MS Clip volumes, including capability to define a thickness for point clouds and project the Point...
over 2 years ago in All Other / Modeling / OpenBridge Designer / OpenBridge Modeler / OpenRail Designer / OpenRail Overhead Line Designer / OpenRoads Designer / OpenSite Designer / OpenTunnel Designer 0 Future consideration

Set Wingwall Height at End

Include option to specify wingwall height at either the start or end of wingwall. Currently, the height can only be set at the start or end closest to the abutment backwall if the user is choosing to slope the top of wing to match the profile.
9 months ago in Modeling / OpenBridge Modeler 0 Future consideration