Need Support? Let’s guide you to the right answer or agent.

OpenTunnel Ideas Portal

ADD A NEW IDEA

Applications

Showing 1447

Replacing the end element(s) of a complex element

There should be tools to allow the end elements in a complex element to be replaced by the designer. The Redefine tool can be fine for elements in the middle and the append tool may be fine for just adding but if I want, for example, to swap the l...
about 2 years ago in Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer 15 Already exists

Vertical curve from element with outgoing slope

When creating vertical curves "from element" it would be really useful to be able to set the outgoing slope (I have not been successful using "civil accudraw" for this purpose...).
about 2 years ago in Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

Place a line between two imported points

OpenRoads should have a Command that place a line between two imported points (.asc, .crv, .txt file) V8i does have a command that will place a line between two imported points. After importing the points into the drawing, you click on the "line c...
over 1 year ago in Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer / Survey 0 Already exists

Dynamic leader to Civil Labeler

It would be nice if Civil Labeler could have dynamic on/off leader. If the label text is moved x.xxm away from insertion point, the leader become visible.
about 1 year ago in Annotation / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

Adding a toggle option to control superelevation section automatic recalculation

Providing a toggle to control the automatic recalculation of superelevation values when the alignment it is dependent on is revised will help limit re-work needed to customize the superelevation values for a project. Exporting and reimporting supe...
7 months ago in OpenRail Designer / OpenRoads Designer / Superelevation 0 Future consideration

Application to read DGN schema and open the relative ORD version

When opening a DGN file, have an application read the schema and then open the corresponding version of software. Currently, users with 'side by side' installation of ORD have to manually decide which product to open each time, and memorize which ...
over 2 years ago in OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

Squeeze Characters

Users need the ability to squeeze letters and spacing word by word in order to get long words to fit on custom signs.
7 months ago in OpenRoads SignCAD 1 Planned

Changing end condition priorities

Can there be a function which end condition priorities can be changed without modifying the template. For example if priority 1 end condition is for a fill batter and priority 2 is for a table drain. Over a given chainage range can a function be c...
over 1 year ago in OpenRoads Designer 2 Already exists

Pile Embed Length Manual Override

A standard Pier type used in our state typically calls out two lengths of pile ('Long' and Short') that alternate along the width of the Substructure. An example plan is attached. If the ' Embed Length ' variable had a manual override option to ch...
about 1 year ago in OpenBridge Modeler 0 Future consideration

Display Civil Accudraw Controls on Geometry created using Offset Tools

When geometry is created using the Horizontal Offset Tools, if the geometry is controlled using Civil Accudraw snaps this is not reflected in the Properties Tab for start and end points. This makes adjusting the Civil Accudraw snaps difficult, suc...
about 1 year ago in OpenRail Designer / OpenRoads Designer / OpenSite Designer / User Interface 0 Future consideration