Need Support? Let’s guide you to the right answer or agent.

OpenTunnel Ideas Portal

ADD A NEW IDEA

Applications

Showing 1385

Allow new Line of Sight analysis to be included in Civil Cells

The new Line of Sight tool is a great addition to the visibility toolset, however, automated repetitive checks are still not possible. As the "standard" Line of Sight checks are usually for things like approach to stop lines and fixed objects, int...
about 2 years ago in Analytics / Modeling / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

Pile Embed Length Manual Override

A standard Pier type used in our state typically calls out two lengths of pile ('Long' and Short') that alternate along the width of the Substructure. An example plan is attached. If the ' Embed Length ' variable had a manual override option to ch...
about 1 year ago in OpenBridge Modeler 0 Future consideration

Display Civil Accudraw Controls on Geometry created using Offset Tools

When geometry is created using the Horizontal Offset Tools, if the geometry is controlled using Civil Accudraw snaps this is not reflected in the Properties Tab for start and end points. This makes adjusting the Civil Accudraw snaps difficult, suc...
about 1 year ago in OpenRail Designer / OpenRoads Designer / OpenSite Designer / User Interface 0 Future consideration

Replacing the end element(s) of a complex element

There should be tools to allow the end elements in a complex element to be replaced by the designer. The Redefine tool can be fine for elements in the middle and the append tool may be fine for just adding but if I want, for example, to swap the l...
about 2 years ago in Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer 15 Already exists

Vertical curve from element with outgoing slope

When creating vertical curves "from element" it would be really useful to be able to set the outgoing slope (I have not been successful using "civil accudraw" for this purpose...).
about 2 years ago in Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

Add Equilibrium Constant to Design File Settings

We need better access and configuration for this constant. There is no place to set this constant.
about 1 year ago in CANT / OpenRail Designer 0 Future consideration

Clipping reference

It will be helpful to see where the clipping is coming from. Example if reference file then would be helpful to know what reference file
about 1 year ago in OpenRail Designer / OpenRoads Designer / User Interface 0 Future consideration

Geometry Connector: automatically use turnout radius when connecting an arc to a turnout

When using Geometry Connector to connect turnouts, it is often that we must extend the last arc of the turnout. Because the arc is in the turnout we cannot extend it. Instead, we must add an arc of same radius. It would be nice that in such situat...
7 months ago in Geometry / OpenRail Designer 0 Future consideration

Changing end condition priorities

Can there be a function which end condition priorities can be changed without modifying the template. For example if priority 1 end condition is for a fill batter and priority 2 is for a table drain. Over a given chainage range can a function be c...
over 1 year ago in OpenRoads Designer 2 Already exists

Application to read DGN schema and open the relative ORD version

When opening a DGN file, have an application read the schema and then open the corresponding version of software. Currently, users with 'side by side' installation of ORD have to manually decide which product to open each time, and memorize which ...
about 2 years ago in OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration