Need Support? Let’s guide you to the right answer or agent.

OpenTunnel Ideas Portal

ADD A NEW IDEA

Geometry

Showing 187

Add Create 3d Automatically Options

The Create 3d Automatically in the Feature Definition toolbar has the potential to be really powerful. Add the ability to have other options. The one I would most like to see is "Profile from Surface" based on vertices, locked to start and end.
over 1 year ago in Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer 1 Future consideration

Add "Auto Activate Profile" to Feature Definition Bar

Add a toggle to activate the next profile that is drawn rather than having to manually activate most profile lines.
over 1 year ago in Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

Allow Vertical Scale in Profile View to Stay Set after "Saved Settings" Or Change Default to 1

Currently, if you change the vertical scale in a profile view, it always reverts back to a vertical scale of 10 if you switch the view to display the profile of a different Line. It would be much better if the scale in the view would stay at whate...
over 2 years ago in Geometry / OpenRoads Designer 0 Already exists

Ability to Change Feature Name of Element Within Complex Element

I would like the ability to change the Feature Name of an element that is part of a Complex Element without having to drop the Complex Element.
over 2 years ago in Geometry / OpenRail Designer 0 Already exists

Geometry builder fix components

As in the geometry connector, the geometry builder needs to be able to fix certain elements
over 2 years ago in Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer 2 Future consideration

Display A parameter (not Length) after using "Create Civil Rule Feature" option.

When I create an alignment with curves using A parameter and when I select this alignment "A parameter" will be properly displayed. Then when I "Remove Rule" and use "Create Civil Rule Feature" tool, A parameter will be replaced with "Length".
over 1 year ago in Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

Snap to specific chainage in Plan

In PRT it was possible to snap a smart line to a specific chainage in plan by using the key-in 'SO=xxx'. In OpenRail the closest tool I can find is Civil Accudraw with station-offset toggled on, but I have found that often CivilAccudraw does not w...
over 1 year ago in Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Already exists

Add a negative function into longitudinal/transverse offsets

Greater flexibility for wingwall placement
over 2 years ago in Geometry / OpenBridge Designer / OpenBridge Modeler 0 Needs review

Profile by best fit - Curve radius

Request to introduce the ability to create a profile by best fit by defining the radius of the arc rather than its length?
over 1 year ago in Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

elevation analysis in profile view

Elevation analysis needs improved within the profile window. Specifically elevation differences. Either at a single station or point, or minimum distances, etc. In the attached screen shot, I would like to know where my minimum distance occurs bet...
over 1 year ago in Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Already exists