Need Support? Let’s guide you to the right answer or agent.

OpenTunnel Ideas Portal

ADD A NEW IDEA

Geometry

Showing 164

Manual Editing of Cant: Make it easier and allow it to be permanent.

The "ruled" cant tries its best to calculate appropriate values of superelevation. Usually, these end up being over-ridden for many reasons, good or bad. Turning off the rules in Cant editor allows manual editing, but it is very time consuming, "r...
about 1 year ago in CANT / Geometry / OpenRail Designer 0 Future consideration

Add Create 3d Automatically Options

The Create 3d Automatically in the Feature Definition toolbar has the potential to be really powerful. Add the ability to have other options. The one I would most like to see is "Profile from Surface" based on vertices, locked to start and end.
about 1 year ago in Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer 1 Future consideration

Add "Auto Activate Profile" to Feature Definition Bar

Add a toggle to activate the next profile that is drawn rather than having to manually activate most profile lines.
about 1 year ago in Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

Cell in GC will have additional properties for IFC

Placed cells with Generative components on alignment which have assigned item types as additional properties. Those properties will be later exported to IFC. Now the additional properties are not shown in GC only in ORD.
about 2 years ago in Geometry / Import/Export / OpenBridge Designer / OpenBridge Modeler / OpenRail Designer / OpenRail Overhead Line Designer / OpenRoads Designer / OpenSite Designer / OpenTunnel Designer 0 Future consideration

Add option to choose between a vertical offset and a parallel offset for profiles

The profile offset transition has the ability to do an vertical offset of (a part of) an profile. This is a vertical offset. When the line is horizontal, the parallel offset is constant. Please add an option to choose between a vertical offset and...
over 1 year ago in Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer 1 Future consideration

Modify circle in complex geometry by center point

In complex geometries it does not seem to be possible to move the center point of a circular curve. When working with different alternatives, it´s common to have two geometries that shares some part of a circular curve with different start or end....
over 1 year ago in Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

Display A parameter (not Length) after using "Create Civil Rule Feature" option.

When I create an alignment with curves using A parameter and when I select this alignment "A parameter" will be properly displayed. Then when I "Remove Rule" and use "Create Civil Rule Feature" tool, A parameter will be replaced with "Length".
about 1 year ago in Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

Ability to Edit Event Point List within Actived Referenced DGN

Activating a referenced dgn with geometry does not allow editing the Event Point List.
about 2 years ago in Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

Symbol to easily display which profile is active

When multiple profiles are drawn in one alignment or civil feature, the user has to hunt for which one is set active. If they are close to each other and/or the same feature definition this is quite tedious! It would be helpful if there was a way ...
7 months ago in Geometry / User Interface 0 Future consideration

Improve civil geometry constraints

Provide an option to quickly apply combined horizontal and vertical constraints to geometry elements. Where geometry lines (breaklines) intersect, they need to share a common elevation. The current process requires creating profile intersection po...
about 2 years ago in Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration