The existing Locate Point tool using the Traverse and Radial methods functionally does something similar, but must have 180 degrees added manually to the deflection angles to get the absolute angle.

Though we can change the symbology for the different projected profile in the Multiple Profile tool, it will be much easier for users to be able to see the geometry name as they move along the profile. This prevents confusion and provides clarity.

I would like the ability to control the limits of the profile run in profile sheets which would also allow me to control the stationing without having to create a separate alignment and project the drainage run into the separate alignment.

Whenever you have a Geometry and used shared line (e.g. Lots), There should be a tool to remove duplicate/overlapping lines. Its problematic if we use a special linestyle with gaps and when the two line on top of each other it will look like a sol...

Add the ability to target survey Feature Definitions with Horizontal Feature Constraints on Points within Templates. There is a deliverable required on surveyors to show cross sections of their surveyed surface where sections within the surface ha...

I would like Geometry Points to support using parametric cells.

What I envision, would be the ability to define Math within a Text Favorite. So, let us say that "[[" would define the start of math in a text favorite. A text favorite could be created in that the value displayed, is math from element properties....

My state agency commonly uses gutters with a 4% cross slope. The maximum superelevation rate is 7%. The gutter slope stays at 4% in this situation. Spread does not compute in this scenario because "A depressed gutter must have a Gutter Cross Slope...

It would be nice to be able to export a drainage network into 2D linework that can be edited for plan sheets. Currently, we don't use our modeled files directly in our plan sheets as we cannot adjust the conduit line styles and it takes longer to ...

When creating parcels in Geometry Builder, I would like the option to have it automatically add COGO/Geometry Points at the PIs and on-alignment points as I place the elements.