Need Support? Let’s guide you to the right answer or agent.

OpenTunnel Ideas Portal

ADD A NEW IDEA

Geometry

Showing 160

Add Elevations to the Event Point List Table

The elevations of the event point can only be seen when one generated a Horizontal Alignment Event Point List Report. It would be better also if the elevations can be seen earlier in the Event Points List Table
8 days ago in Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

Geometry Connector: automatically use turnout radius when connecting an arc to a turnout

When using Geometry Connector to connect turnouts, it is often that we must extend the last arc of the turnout. Because the arc is in the turnout we cannot extend it. Instead, we must add an arc of same radius. It would be nice that in such situat...
2 days ago in Geometry / OpenRail Designer 0 Future consideration

Linear Template - the BSplines warning is not helpful

When you place a Linear Template on a splined element a warning is generated which requires user interaction to dismiss: "Warning: The base geometry selected for this corridor contains B-Spline elements for the horizontal Transitions. Consider rec...
7 days ago in Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer / User Interface 0 Future consideration

Create Geometry Points in Geometry Builder

When creating parcels in Geometry Builder, I would like the option to have it automatically add COGO/Geometry Points at the PIs and on-alignment points as I place the elements.
3 months ago in Geometry / OpenRail Designer / OpenSite Designer 2 Future consideration

Normal/parallel offset in vertical profile

In ORD it is possible to do a Profile Offset Transition. This methode makes a vertical offset. In case of a slope, the difference between the vertical offset and the normal/parallel offset is different. For large slopes, this is differences is too...
28 days ago in Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer 2 Future consideration
161 VOTE

Drawing layout from right to left - plan and profile.

Fundamental convention for technical drawing demands that the north arrow point to the top of the page. Often an alignment either provided by a client or already exiting will progress from right to left. This being said, when creating plan and pro...
about 2 years ago in Drawing Production / Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer 5 Planned

Snapping to arc/spiral end in profile

I would highly recommend to let user to snap to arc or spiral end in profile design. As you can see in the attached video I can't find intersection between profile alignment and vertical line that indicates arc/spiral end. To find intersection b...
9 months ago in Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer 0 Future consideration

Need ability of having different Spiral Types in OpenRoads Designer

Need to have an option of having different spiral curve types in OpenRoads Designer mainly cubic parabola which is similar in OpenRail Designer. This is also required to satisfy new expressway design specification as per table no 2.4 in clause no ...
5 months ago in Geometry / OpenRoads Designer 0 Future consideration
111 VOTE

Separate vertical alignment model from horizonal geometry

One of my biggest pain points about ORD is if the horizontal geometry is dropped or broken, the vertical is consequently lost as well. This creates significant rework from a design and plan production standpoint (connected named boundaries). One w...
almost 2 years ago in Geometry / OpenRail Designer / OpenRoads Designer / OpenSite Designer 2 Future consideration
127 VOTE

Show and annotate projected points on profile view

Show and annotate projected points on profile view. This is for dynamic and drawing production profiles.
about 2 years ago in Annotation / Geometry / OpenRail Designer / OpenRoads Designer 3 Future consideration